A-10 Thunderbolt II RTF 4CH RC Brushless Scale Model Jet
Cat #: OOS
Rating: 25/5
Stock Level: Out Of Stock
Estimated Delivery Time: 2-3 Days
The A-10 Thunderbolt II (also known as the Warthog) comes with all electronics and radio gear included and is the upgraded version featuring twin brushless motors and 2.4Ghz radio equipment. You will not find a 2.4G twin brushless jet that is better priced than this. The A-10 has superb manoeuverability even at low speeds and altitude, this is due to its large wing area, high wing aspect ratio, and large ailerons. This design also enables short takeoffs and landings, allowing it top operate from the smallest and most basic airfields.
This model replica of the A-10 Thunderbolt II requires only minor assembly such as attaching the wings etc so you can get it in the air within minutes of opening the box. Once assembled this plane looks amazing and quite imposing with a wingspan of nearly three feet!
When it is airbourne it has full four channel radio control, allowing adjustment of the aileron, elevator, throttle, and when the plane is on the ground, it is complete with front wheel steering.
Powered by twin 2410 brushless motors(1200KV) this plane is capable of high speed, 3D aerobatic stunts and also is able to fly in windy conditions. The A-10 is a confident acrobat and capable of a full range of impressive tricks and maneuvers in experienced hands. It can perform: inside loops, outside loops, axial rolls, inverted flight, knife edge, stall turns, hammerheads, and spins. Despite its aerobatic pedigree, the same design that gives it the ability to carryout breathtaking 3D moves, means it is a stable plane and so also suitable for the beginner and mid-level pilot too.
The Thunderbolt has been fitted with twin powerful brushless motors, and a 2.4Ghz radio transmitter for more stable control and a longer range. The brushless motors are powered by a 11.1V Li-polymer battery instead of the standard Ni-Mh. It is the perfect choice for the enthuiast.
This plane is described as RTF or ready to fly, this means that everything except batteries for the transmitter is included in the box and that only a few minor stages of assembly remain, such as attaching the wings and tailplane. These steps should take around 30 minutes to complete.
Features
* 4 CH Full RC - Aileron, Elevator, Wheel, Throttle
* Upgraded 2.4Ghz Radio Equipment
* Twin Brushless Motors
* Full aerobatic characteristics
* Powerful brushless motors
* Excellent stability
* Ready to Fly in Just Minutes!
* Super tough & Lightweight
* Shock Resistant Fuselage
* Pre-installed Electronics
* Suitable for beginners and experts
* Only required 8 AA batteries for the transmitter to start flying
* 10-15 minutes flight time
